In this section, we will detail waterjet installation hydraulic oil requirements. These operating rules require thorough understanding to all of the components.
Hydraulic oil is the blood of the ultra-high pressure pump. Use correct hydraulic oil is the basic guarantee of equipment operation. Unreasonable application will result in equipment damage and personal injury.
Use No. 46 anti-wear hydraulic oil or the same level anti-wear hydraulic oil. Please use mineral oil series anti-wear hydraulic oil. Volume is 100L.
Before fill the tank, it is required to filter the anti-wear hydraulic oil. Filtration precision should be at least 25渭m.
Don't operate the hydraulic system if there is potential danger. This could cause serious accidents such as fire and explosive.
Hydraulic oil is flammable. So do not expose to open fire, or weld near the equipment. Otherwise it may cause a fire.
Please avoid splashing hydraulic oil to the people. Please wash thoroughly with soap if the hydraulic oil is on the skin. It may also harm the skin if hydraulic oil is splashed on the skin.
There is no anti-wear hydraulic oil in the pump, in order to prevent leak during transport and cause accident. It is required to fill anti-wear hydraulic oil before operation.
High pressure pipe is used for transporting cutting water from ultra-high pressure pump to the cutting head.
Before installation, high pressure pipe should be well prepared. Ensure that the high pressure pipe is clean and free of oil. If high-pressure pipe needs to be bended, the bending radius should be more than 500 mm.
When installing a high-pressure tube, it is required to clean up the threads of the tube and the fittings first. Make sure there are no sand and other dirt. Then grease the threads.
High pressure pipes and pipe fittings must have the right sizes. They are required to be provided by the All-Powerful company.
Do not over tighten the high pressure fittings; otherwise it will shorten the service life of the high pressure pipe, or cause damage of the fittings and the Tubes.
Controlling cable is used for remote control of ultra-high pressure pump. Through the remote controller it is easy to operate the pump automatically.
Before the installation, the user should clean up the dirt on the connector, so as not to cause poor contact. After butt joint, lock the connection by rotate the fittings clockwise.
Specifications of the connector pins are different; please make sure you connect it in the right way. If there is failure about the connection, there will be damage of the machine.
Prepare adjustable wrenches and Allen wrenches in different sizes.